NEXO NXAMP4x1 Dante

Descriptions détaillées

POWER SPECIFICATIONS FOR NXAMP Powered TDcontroller

• Number of channels : 4 channels, 3 channels (2 non bridged + 1 bridged) or 2 channels (2 bridged)
• Max. output power (8 Ω) : 600 W (non bridged) / 1800 W (2 channels bridged)
• Max. output power (4 Ω) : 900 W (non bridged) / 2600 W (2 channels bridged mode)
• Max. output power (2 Ω) : 1300 W (non bridged)
• Power consumption : 10 W Standby, 100 W Idle, 1100 W 1/8 Power

SPECIFICATIONS FROM ANALOG IN TO POWER OUT

• Analog Inputs channels : 4 channels analog inputs on XLR 3 with a second XLR 3 for linking
• Frequency response : +/- 0.5 dB from 10 Hz to 20 KHz
• Input Impedance : 20 KOhm.
• Max Input Level : +28 dBu
• Dynamic Range : All Channels = 105dB unweighted
• THD + Noise : Typical 0.1% flat setup
• Latency time : 2.2 ms on a flat setup (Compatible with NX241 and NX242)
• Power Supply : Dedicated version for 100 ~ 120 Volts or 220 ~ 240 Volts

FRONT AND BACK PANEL FEATURES

• Audio Inputs : 
  • 4 balanced analog inputs on XLR with link, using 24 bit converters.
  • 4 digital inputs via the optional network card slot at the back.
• Power Outputs : 4 Speakon outputs
• RS232 port : Allow firmware upgrade for software improvement and new cabinet setups.
• GPIO port : 5 Global Purpose Inputs and 8 Global Purpose Outputs
• Front Panel : On/Off switch, Wheel, A/B buttons, 40 char x 2 display. Amp protect/Stand-by/Power LED’s. For each ch: volume (15 LEDs), Mute w LED, Output current LED, Protect LED, Peak LED.
• Rear Panel : 1 mains socket (2 for NXAMP4X4); RS232; GPIO, Expansion slot, 4 XLR w link, 4 Speakon 4

USER CONTROLS

• System Selection : Allows control from all NEXO ranges.
• System Set-up : Within the selected range when possible, allows the cabinet to be set for passive/active mode, wideband/crossover mode, choose among crossover point, cardiod/supercardiod mode.
• Protection : Multiple Peak Limiters fitted for both selected cabinet and amplifier. Multiple Acceleration, Displacement and Temperature protections on every channel.
• Delay : Up to 66m (145 ft.) of delay in 10cm (.4in ) steps
• Input Patching : Any of the 4 analog (or 8) inputs combination to be routed on each output.
• Output Gain : Global and inter-channel gain +/-6dB in 0.5dB steps.
• Volume control : Each channel with 16 steps from – inf dB to 0 dB.
• Save/Recall : Set-up Stores 32 user set-ups
• Array EQ : LF/HF shelving filters to compensate ground/stacking effects, +/-6dB
• Security Mode : Password protected for Read-Only or Remote-Only Mode.
• Remote control : Full remote control via the Ethersound protocol and ESmonitor software.
• Certification : UL, SEMKO (CE), CCC, KOREA, TSS, PSE
• Green status : Compliant with ROHS and WEEE directive

Vue objet Quicktime VR® :

Cliquez-glissez votre souris sur l'objet pour le visualiser en 3D sous 360°